3/26/2023 0 Comments Rockstar halloween costume![]() ![]() The second layer will then be the Everyday Iron On. If the clear transfer sheet won’t come off without the design lifting, then apply another 5-10 seconds of heat and try again. This is because you’ll be adding additional heat with each additional layer. Then you’re going to apply heat from the EasyPress 2 at 330 degrees for only 20 seconds, instead of 30 seconds. Heat the area for a few seconds, prior to placing your design. You always start with the HIGHEST heat-temperate layer first! So, for this design, we started with the Holographic Sparkle Iron On. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |